If the Antminer S17 kernel log shows Chain 1 find 0 asic (as shown in the figure below), you can refer to several methods in this article for troubleshooting. 2022-05-07 08:49:17 driver-btm-api.c:915:check_asic_number_with_power_on: Chain[l]: find 0 asic, times 0 2022-05-07 08:49:28 driver-btm-api.c:915:check_asic_number_with_power_on: Chain[l]: find 0 asic times 1 2022-05-07 08:49:39 driver-btm-api.c:915:check_asic_number_with_power_on:
Our articles talk about Bitcoin from top to bottom. We explore all general concepts and more specific concepts related to Bitcoin mining.
Refresh screen glitches are repeated by posting the same message on the same page or sending the same message on different pages. When the miner’s kernel log has a refresh screen failure, how do we troubleshoot the failure? Mar 1 14:20:39 (none) local0.err cgminer: Net Err! lastest job more than
An Antminer S17 hashboard has 48 chips, but the kernel log finds 16 chips (as shown in the figure below); so, when we encounter this problem, how should we solve them? 2022-05-07 08:49:51 driver-btm-api.c:915:check_asic_number_with_power_on: Chain: find 16 asic, times 0 2022-05-07 08:50:02 driver-btm-api.c:915:check_asic_number_with_power_on: Chain: find 16 asic, times 1 2022-05-07 08:50:13
The temperature sensor chip is mainly used to sense the temperature of the hash board and its surroundings. If it is damaged, it will cause abnormal temperature readings, and the hash board will not start when the temperature is too low (the kernel log shows that the temperature sensor reading failed),
According to the backstage kernel log, Antminer S17+ read the temp sensor failed, which means the temperature sensor chip is faulty. In this case, the hashboard will not start, or the miner will stop running. 2022-05-08 03:00:34 temperature.c:843:get_temp_info: read temp sensor failed: chain = 0, sensor = 2, chip =
If the kernel log shows “ERROR_SOC_INIT,” it means that the Antminer S17+ hash board is mixed with inconsistent code, you can troubleshoot by following steps. 2022-03-11 08:38:21 voltage = 1710 2022-03-11 08:38:21 voltage = 1690 2022-03-11 08:38:21 voltage = 1710 2022-03-11 08:38:21 Voltage are different. Will exit. 2022-03-11 08:38:21 driver-btm-api.c:205:set_miner_status:
When Antminer S17+ kernel log shows Chain 0 only finds 0 ASIC, will cause miners to stop mining, you can troubleshoot by following steps. 2021-05-04 14:22:57 driver-btm-api.c:1162:check_asic_number_with_power_on: Chain: find 0 asic, times 0 2021-05-04 14:23:06 driver-btm-api.c:1163:check_asic_number_with_power_on: Chain: find 0 asic, times 1 2021-05-04 14:23:17 driver-btm-api.c:1164:check_asic_number_with_power_on: Chain: find 0 asic, times