How to fix “Chain only find 0 ASIC” on Bitmain Antminer S17+ ASICs
If you’re an ASIC miner and are experiencing the issue of “Chain only find 0 ASIC” on your Bitmain Antminer S17+ ASICs, it can be frustrating and concerning. This error message indicates that the hash board is unable to detect any of the ASICs on the chain, which can lead to decreased mining efficiency or even total failure of the mining operation. However, there are a few steps that you can take to troubleshoot and fix this issue. This guide will provide you with a step-by-step approach to identify the root cause of the problem and implement the necessary solutions to get your Bitmain Antminer S17+ ASICs back up and running efficiently. It’s important to note that these steps should only be attempted by someone with experience in ASIC mining and electronics, and caution should be taken to avoid any potential risks involved in handling and modifying the hardware.
Troubleshooting Steps to fix “temperature sensor fault” on Bitmain Antminer S17e
Check the kernel log: The first step is to check the kernel log of your Bitmain Antminer S17+. Look for “check_asic_number_with_power_on: Chain[0]: find 0 asic, times 0” or “check_asic_number: Chain 0 only find 0 asic, will power off hash board 0” messages. This will help you identify which chain has the issue.
Swap data cables: Once you’ve identified the problematic chain, swap the data cable of the hash board that’s showing the “Chain only find 0 ASIC” message with the data cables of two other normal hash boards. This step helps to determine if the issue is with the cable or the hash board itself.
Check voltage domain: If swapping the data cables doesn’t fix the issue, use a fluke17B+ multimeter to check whether the total voltage domain of the hash board is normal. If it’s abnormal, you need to check whether the voltage of each PIC, MOS tube, and boost circuit is abnormal.
Check RI signal voltage: If the voltage domain is normal, check the RI signal voltage. First, find the RI signal of a group of chips on the edge of the domain for detection in the middle domain. If it’s normal, check it forward. If it’s abnormal, check it backward. The RI signal is transmitted from the last chip to the first chip.
Check for chip pseudo-soldering: If the kernel log and test fixture detection show “ASIC=0 or NO hash board”, check whether the chip’s RI signal voltage and the ground value are abnormal. If there’s any abnormality, it’s likely caused by chip pseudo-soldering. Soldering twice first. If it cannot be solved, replace the faulty chip.
Seeking Professional Assistance for Your ASIC Mining Issues: D-Central ASIC Repair Services
In conclusion, the “Chain only find 0 ASIC” issue can be a frustrating and challenging problem to solve, but with patience and the right troubleshooting approach, you can identify and fix the problem. We’ve provided a step-by-step guide to help you troubleshoot and fix the issue on your Bitmain Antminer S17+ ASICs.
However, if you find that the issue persists, or you don’t feel comfortable attempting the troubleshooting steps yourself, it may be time to seek professional assistance. At D-Central, we provide high-quality ASIC repair services to help you get your mining operation back up and running as quickly and efficiently as possible.
Our team of experienced technicians has the expertise and knowledge to diagnose and fix a wide range of ASIC mining issues, including “Chain only find 0 ASIC.” If you’re having trouble fixing the issue yourself, don’t hesitate to contact us for professional assistance. Visit our website to learn more about our services and how we can help you fix your ASIC mining issues today.
