4479 Desserte Nord Autoroute 440, Laval, QC H7P 6E2

This guide applies to most ANTMINER models. It will guide you step-by-step through the process of disassembling your miner. Disassembling your miner can be useful for troubleshooting, maintenance, or repair purposes.

What You’ll Need:

  1. Antistatic Wrist Strap: To prevent any potential static electricity damage to your miner’s components.
  2. Screwdriver: To remove screws from the miner’s case and other parts.

Steps for Disassembling:

Step 1: Safety Precautions

Always ensure that the miner is turned off and unplugged from the power source before you start disassembling it. Put on your antistatic wrist strap to ground yourself and prevent any potential static electricity damage.

Step 2: Removing the Case

Most ANTMINER models have a metallic case secured with screws. Locate these screws, generally found on the top and bottom of the miner, and remove them using your screwdriver.

Step 3: Extracting the Fans

With the case removed, you’ll now see the miner’s internal components, including one or two cooling fans. These fans are usually attached with screws. Remove these screws and carefully extract the fans from the miner.

Step 4: Detaching the Hash Boards

Next, you’ll see the hash boards. These are the heart of your ANTMINER, carrying out the intense computation work of mining. Be extra cautious when handling these. They’re usually attached to the miner with connectors. Carefully disconnect these connectors to remove the hash boards.

Step 5: Removing the Control Board

The control board is the brains of your ANTMINER, controlling its operation and communicating with your network. It’s typically smaller than the hash boards and located separately. Like the hash boards, it’s usually attached with connectors. Carefully disconnect these to remove the control board.

Step 6: Inspecting and Cleaning the Components

With your miner now fully disassembled, you can inspect its components for any signs of damage or dust build-up. If you’re disassembling your miner for cleaning, now’s the time to carefully remove any dust with a soft brush or compressed air.


To reassemble your miner, follow the disassembly steps in reverse. Always ensure that you securely attach all components and connectors, and that the miner’s case is properly reattached.

Remember, disassembling and reassembling your miner should be done with great care. Mistakes could lead to damage, reduced performance, or even a complete failure of your miner. If you’re not comfortable performing these steps, consider seeking professional help.