Skip to content
Small team, full backlog, zero orders dropped. Support replies are slower than we’d like. Read our status update → Zero orders dropped. Status → 📬 Check your spam folder — most of our replies land there. We do answer. Status update → 📬 Check your spam folder. Status →
Goldshell DG MAX specifications and service reference ASIC miner reference image
Lifecycle not independently verified Goldshell Scrypt

Goldshell DG MAX specifications and service reference

Goldshell DG MAX official 6.5 GH/s Scrypt matrix, electrical boundary, physical fields, and exact-model firmware.

Scrypt hashrate6.5 GH/s ±5%
Documented power3450 W ±5%
Native efficiency530.7692 J/GH derived; no independent tolerance

Quick answer

The Goldshell DG MAX specifications and service reference is a Scrypt miner rated about 6.5 GH/s at roughly 3,450 W.

Full Specifications

Full technical specifications for this miner.
Model Goldshell DG MAX specifications and service reference
Manufacturer Goldshell
Algorithm Scrypt
Hashrate 6.5 GH/s
Power Consumption 3,450 W
Efficiency 530.7692 J/GH
Noise Level 60 dB
Voltage Range 180-280 V
Operating Temperature 0-35 C
Dimensions 264 x 200 x 290 mm
Weight 13.5 kg
Status Lifecycle not independently verified

Manufacturer-supported specification

Goldshell DG MAX

Goldshell publishes one default Scrypt operating lane for DG MAX: 6.5 GH/s ±5% at 3450 W ±5%, labeled 0.53 J/MH. The manufacturer lists Litecoin and Dogecoin for this exact model.

Exact operating lane

Mode Hashrate Power OEM efficiency
Default 6.5 GH/s ±5% 3450 W ±5% 0.53 J/MH

The OEM efficiency label is preserved in its native unit. Dividing nominal power by nominal hashrate gives approximately 530.77 J/GH; this is transparent arithmetic, not a second manufacturer specification. No low-power row is published in the cited table.

Electrical and environment

The manufacturer table lists 180–280 V input, Ethernet networking, recommended operating temperature 0–35°C, relative humidity at or below 65%, and a 6000 rpm fan specification. Its separate Power Cable Specification field says 16 A. That label is reproduced as a cable requirement and must not be reinterpreted as measured current, breaker sizing, phase, frequency, plug, conductor, or overcurrent-protection guidance.

Verify the unit nameplate, site voltage, cord, connector, frequency, phase, and protective devices with a qualified installer before energizing it.

Physical and acoustic fields

Miner dimensions are 264 × 200 × 290 mm and net weight is 13.5 kg. Package dimensions are 370 × 305 × 450 mm and packaged weight is 15 kg. The manufacturer states noise at or below 60 dB; test geometry and acoustic method are not published, so treat it as the exact table label rather than a site guarantee.

Exact-model firmware

The official DG MAX directory contains firmware-Goldshell-DGMAX-2.2.5.cpb and firmware-Goldshell-DGMAX-2.2.16.cpb. Confirm the exact DG MAX label before selecting either artifact. Goldshell says an upgrade is unnecessary when operation is normal; once an upgrade begins, do not turn off power or operate the miner.

Official DG MAX firmware directory · Official DG MAX specification table

Service boundary

No chip process/count, board count, controller model, PSU architecture, tuning, residential-use score, heat-use claim, economics, profitability, or parts-interchangeability claim is made. Adjacent models remain separate.

Request ASIC repair · Use the ASIC fault finder